lucene-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From "心如止水" <>
Subject 回复: 回复:build solr source
Date Fri, 28 Sep 2012 16:02:55 GMT
Hi both,
 Thank you very much .
 But in which directory to run the ant clean-eclipse eclipse command  ? 
 I check out use this command 
 svn checkout lucene_trunk 
 So should I run the command in the lucene_trunk dir or lucene_trunk/Solr dir ?
 and as Jack  say "refresh" the project , does the project refer to lucene_trunk/Solr project
imorted in eclipse ?


 ------------------ 原始邮件 ------------------
  发件人: "Jack Krupansky"<>;
 发送时间: 2012年9月28日(星期五) 晚上11:53
 收件人: "dev"<>; 
 主题: Re: 回复:build solr source


   Thank you!
-- Jack Krupansky
  From: Uwe Schindler 
 Sent: Friday, September 28, 2012 11:30 AM
 Subject: RE: 回复:build solr source


Since 2 hrs there is now also „ant clean-eclipse“, so after checkout only “ant clean-eclipse
eclipse” would do a clean setup. No resolve/clean-jars needed, as this is all done automatically.
Uwe Schindler
H.-H.-Meier-Allee 63, D-28213 Bremen

From: Jack Krupansky [] 
Sent: Friday, September 28, 2012 5:04 PM
Subject: Re: 回复:build solr source

I always run “ant clean clean-jars resolve eclipse” after checkout, delete the eclipse-build
directory, then do “refresh” in eclipse.


-- Jack Krupansky


From: 心如止水 

Sent: Friday, September 28, 2012 10:52 AM

To: dev 

Subject: 回复:build solr source


Hi all,

when I check the solr source out , and run ant eclipse command and then import into eclipse
,there are some error occur : Analyzer cannot be resolved to a type 

and AbstractAllGroupHeadsCollector cannot be resolved and Type _TestUtil cannot be resolved
? someone can tell me how to solve this ?
View raw message