incubator-blur-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Gagan Juneja <gagandeepjun...@gmail.com>
Subject Re: piped commands | selector
Date Tue, 17 Sep 2013 06:15:24 GMT
I think we can simply represent it as
selector reset or selector add <family> [<columnName>*]

What do u say?

Regards,
Gagan

On Mon, Sep 16, 2013 at 10:13 PM, Aaron McCurry <amccurry@gmail.com> wrote:
> Agreed, what should it be?
>
>
> On Mon, Sep 16, 2013 at 11:40 AM, Gagan Juneja <gagandeepjuneja@gmail.com>wrote:
>
>> ohhk.. so "|" here means is or I took it as unix "I". Can we change
>> this because "|" holds significance in shell.
>>
>> Regards,
>> Gagan
>>
>> On Mon, Sep 16, 2013 at 6:43 PM, Aaron McCurry <amccurry@gmail.com> wrote:
>> > If I remember correctly, the reason for the "|" is not to be executed
>> > together.  But rather to show that you can use "selector reset" or
>> > "selector add family [columns*]".  They aren't meant to be used together.
>> > What do you think would be a better indicator of the 2 uses of the
>> command?
>> >
>> > Aaron
>> >
>> >
>> > On Mon, Sep 16, 2013 at 8:20 AM, Gagan Juneja <gagandeepjuneja@gmail.com
>> >wrote:
>> >
>> >> Hi,
>> >> I was doing some hands on with the Blur shell and found that the pipe
>> >> separated commands specially following command is not working as
>> >> expected.
>> >> selector reset | add family [columns*]
>> >>
>> >> If I run these commands separately like
>> >> selector reset
>> >> selector add family [columns*]
>> >>
>> >> It's working perfectly fine. Can you please validate this.
>> >>
>> >> Regards,
>> >> Gagan
>> >>
>>

Mime
View raw message