httpd-users mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From "georg" <georg.chamb...@telia.com>
Subject Re: [users@httpd] fedora - apache
Date Sun, 14 Apr 2013 15:00:39 GMT
Tnx a million for all substancial advice, have been needing to work so
will check an test your clues and come back soon.

Georg

----- Original Message ----- 
From: "John Iliffe" <john.iliffe@iliffe.ca>
To: <users@httpd.apache.org>
Sent: Saturday, April 13, 2013 9:28 PM
Subject: Re: [users@httpd] fedora - apache


> You might also check that the ENTIRE ifcfg-eth0 configuration is there.  I
> installed RHEL6 and the file was truncated for some reason.  Fedora is 
> very
> similar so could have made the same error.
>
> FYI, the entire file should look more or less like this:
>
> DEVICE="eth0"
> BOOTPROTO=none
> NM_CONTROLLED="yes"
> ONBOOT=yes
> TYPE="Ethernet"
> UUID="be94de20-47e0-441a-ab6b-454a17ae89ed"
> HWADDR=50:46:5D:06:BA:DB
> IPADDR=192.168.1.18
> PREFIX=24
> DNS1=192.168.1.1
> DEFROUTE=yes
> IPV4_FAILURE_FATAL=yes
> IPV6INIT=no
> NAME="System eth0"
> NETMASK=255.255.255.0
> GATEWAY=192.168.1.1
>
> Regards,
>
> John
> =======================================
> On Saturday 13 April 2013 10:48:25 Adam Dosch wrote:
>>  I believe since around Fedora 15, all network devices take on a new
>>  naming convention based (see
>>  http://fedoraproject.org/wiki/Features/ConsistentNetworkDeviceNaming).
>>  So looking explicitly for ifcfg-eth* in /etc/sysconfig/network-scripts
>>  would be the case if you're passing kernel boot parameter
>>  'biosdevname=0'.
>>
>>  'lspci' had already been mentioned, and I'd also look in
>>  /sys/class/net/   -> see what devices were found and it will map back
>> to it's PCI bus location.
>>
>>  Case in point, if all that came back on 'ifconfig -a' was loopback,
>>  then you don't have the module loaded to support that NIC device, it's
>>  not bootstrapped to be an 'onboot' device, module is blacklisted
>>  (doubtful, but check /etc/modprobe.d), or something else I'm entirely
>>  overthinking or not grasping this morning.
>>
>>  -A
>>
>>  On Sat, 13 Apr 2013 10:29:37 -0400, Jim Albert wrote:
>> > I expect the interfaces would have been detected and configured
>> > during the linux install, but check:
>> > /etc/sysconfig/network-scripts
>> > for files looking like ifcfg-eth* (probably ifcfg-eth0 if only one
>> > NIC) as those would be your network interface configurations.
>> >
>> > On 4/13/2013 9:49 AM, georg wrote:
>> >> right ifconfig only comes up with local loop i-f,
>> >> so does that mean there is no Hw on the machine for eth ?  (there is
>> >> a
>> >> distinct plugg looking IPish :)
>> >> /georg
>> >>
>> >>     ----- Original Message -----
>> >>     *From:* Serge Fonville <mailto:serge.fonville@gmail.com>
>> >>     *To:* users@httpd.apache.org <mailto:users@httpd.apache.org>
>> >>     *Sent:* Saturday, April 13, 2013 4:10 PM
>> >>     *Subject:* Re: [users@httpd] fedora - apache
>> >>
>> >>     Hi,
>> >>
>> >>     >Possibly you have a hint for where im stuck just now:  Cant
>> >>
>> >> find any
>> >>
>> >>     ethernet > device on the PC im digging into.
>> >>     Perhaps there is no NIC detected.
>> >>     if you run ifconfig and lspci, you should be able to determine
>> >>
>> >> if
>> >>
>> >>     that is the case
>> >>
>> >>     HTH
>> >>
>> >>     Kind regards/met vriendelijke groet,
>> >>
>> >>     Serge Fonville
>> >>
>> >>     http://www.sergefonville.nl
>> >>
>> >>     Convince Microsoft!
>> >>     They need to add TRUNCATE PARTITION in SQL Server
>> >>
>> >> https://connect.microsoft.com/SQLServer/feedback/details/417926/trunc
>> >> ate-partition-of-partitioned-table
>> >>
>> >>     2013/4/13 georg <georg.chambert@telia.com
>> >>     <mailto:georg.chambert@telia.com>>
>> >>
>> >>         Terrific, tnx.
>> >>
>> >>         Possibly you have a hint for where im stuck just now:  Cant
>> >>
>> >> find
>> >>
>> >>         any ethernet device on the PC im digging into.
>> >>         (new to linux/fedora, but shurely there should be some eth
>> >>
>> >> ??)
>> >>
>> >>         tnx again
>> >>         Georg
>> >>
>> >>         ----- Original Message ----- From: "How7"
>> >>
>> >> <how0909@freeshell.org
>> >>
>> >>         <mailto:how0909@freeshell.org>>
>> >>         To: <users@httpd.apache.org <mailto:users@httpd.apache.org>>
>> >>         Sent: Saturday, April 13, 2013 3:27 PM
>> >>         Subject: Re: [users@httpd] fedora - apache
>> >>
>> >>             On 4/13/2013 7:45 AM, georg wrote:
>> >>                 I have seen some documentation that indicate that
>> >>
>> >> some
>> >>
>> >>                 version (2.2?) of Apache is
>> >>                 included in the fedora dist.
>> >>                 Does anyone have any information of how to find such
>> >>
>> >> a
>> >>
>> >>                 package and whether these
>> >>                 are good things or if I should go for downloading
>> >>
>> >> other
>> >>
>> >>                 version
>> >>
>> >>             In a terminal on my Fedora 16 I do this to see what
>> >>
>> >> version
>> >>
>> >>             I have installed:
>> >>             ~>  rpm -q httpd
>> >>             httpd-2.2.21-1.fc16.x86_64
>> >>
>> >>             2.2 is fine for me but I just use it to test my work
>> >>
>> >> locally.
>> >>
>> >>             I would use the yum package manager to see what upgrades
>> >>
>> >> are
>> >>
>> >>             available. Maybe:
>> >>             ~>  yum check-update httpd
>> >>
>> >>             View the yum manual page for more information on package
>> >>             management and updating:
>> >>             ~>  man yum
>> >>
>> >>             If you wanted a newer version than is available at the
>> >>             fedora upgrade repos yum looks at you could build from
>> >>
>> >> source.
>> >>
>> >>
>> >>
>> >> ------------------------------__------------------------------__-----
>> >> ----
>> >>
>> >>             To unsubscribe, e-mail:
>> >> users-unsubscribe@httpd.__apache.org
>> >>
>> >>             <mailto:users-unsubscribe@httpd.apache.org>
>> >>
>> >>             For additional commands, e-mail:
>> >> users-help@httpd.apache.org
>> >>
>> >>             <mailto:users-help@httpd.apache.org>
>> >>
>> >> ------------------------------__------------------------------__-----
>> >> ----
>> >>
>> >>         To unsubscribe, e-mail: users-unsubscribe@httpd.__apache.org
>> >>         <mailto:users-unsubscribe@httpd.apache.org>
>> >>         For additional commands, e-mail: users-help@httpd.apache.org
>> >>         <mailto:users-help@httpd.apache.org>
>> >
>> > ---------------------------------------------------------------------
>> > To unsubscribe, e-mail: users-unsubscribe@httpd.apache.org
>> > For additional commands, e-mail: users-help@httpd.apache.org
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: users-unsubscribe@httpd.apache.org
>> For additional commands, e-mail: users-help@httpd.apache.org
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: users-unsubscribe@httpd.apache.org
> For additional commands, e-mail: users-help@httpd.apache.org
> 


---------------------------------------------------------------------
To unsubscribe, e-mail: users-unsubscribe@httpd.apache.org
For additional commands, e-mail: users-help@httpd.apache.org


Mime
View raw message