httpd-docs mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Apache Wiki <>
Subject [Httpd Wiki] Update of "xiaoyinggu" by xiaoyinggu
Date Fri, 12 Nov 2010 07:57:22 GMT
Dear Wiki user,

You have subscribed to a wiki page or wiki category on "Httpd Wiki" for change notification.

The "xiaoyinggu" page has been changed by xiaoyinggu.


  The [[|ball mill]] is a key equipment to grind the crushed
materials, and the ball mill is widely used in powder-making production line including cement,
silicate, new-type building material, refractory material, fertilizer, ore dressing of ferrous
metal and non-ferrous metal, glass ceramics, etc. And the ball mill can grind various ores
and other materials with dry type and wet type. There are two kinds of ball mill, grate type
and overfall type due to different ways of discharging material. Our [[|ball
mills]] can satisfy different requirement, and have good features such as low consumption,
high capacity per hour, no pollution to the enviroment around, easy to be repaired.
- Working Principle:
+ === Working Principle: ===
  The ball mill is a horizontal rotating device transmitted by the outer gear. The materials
are transferred to the grinding chamber through the quill shaft uniformly. There are ladder
liner and ripple liner and different specifications of steel balls in the chamber. The centrifugal
force caused by rotation of barrel brings the steel balls to a certain height and impact and
grind the materials. The ground materials are discharged through the discharging board thus
the grinding process is finished.
  Ball mill is characterized by their smaller (comparatively) diameter and longer length.
The feed is at one end of the cylinder and the discharge is at the other. Ball mill is commonly
used in the manufacture of. This industrial ball mill is mainly big machines. Small versions
of ball mill can be found in laboratories where they are used for grinding sample material
for quality assurance. The power predictions for ball mill typically use the following form
of the bond equation:Ball mill is normally operated at around 75% of critical speed, so a
mill with diameter 5 meters will turn at around 14 rpm. The mill is usually divided into at
least two chambers, allowing the use of different sizes of grinding media. Large balls are
used at the inlet, to crush clinker nodules (which can be over 25 mm in diameter). Ball diameter
here is in the range 60-80 mm. In a two-chamber mill, the media in the second chamber is typically
in the range 15-40 mm, although media down to 5 mm is sometimes encountered. As a general
rule, the size of media has to match the size of material being ground: large media can't
produce the ultra-fine particles required in the finished cement, but small media can't break
large clinker particles. Mills with as many as four chambers, allowing a tight segregation
of media sizes, were once used, but this is now becoming rips. Alternatives to multi-chamber
mills are: Pairs of mills, run in tandem, charged with different-sized media. Use of alternative
technology (see roll-presses below) to crush the clinker prior to fine-grinding in a ball

To unsubscribe, e-mail:
For additional commands, e-mail:

View raw message