httpd-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Jeff Trawick <traw...@gmail.com>
Subject Re: Building the trunk
Date Sun, 23 Sep 2012 14:13:05 GMT
On Sat, Sep 22, 2012 at 3:40 PM, Benson Margulies <bimargulies@gmail.com> wrote:
> On Sat, Sep 22, 2012 at 2:51 PM, Graham Leggett <minfrin@sharp.fm> wrote:
>> On 22 Sep 2012, at 19:20, Benson Margulies <bimargulies@gmail.com> wrote:
>>
>>> I checked out http://svn.apache.org/repos/asf/apr/apr/trunk into
>>> srclib/apr, and then I ran buildconf, and then I tried to run
>>> configure.
>>
>> I am not sure the apr-inside-srclib works any more.
>>
>> In theory, build apr-trunk and make install it to a directory with --prefix, then
point httpd at at by saying ./buildconf --with-apr=/path/to/apr-trunk
>>
>> Apr-uti-trunk was combined with apr-trunk a while back.
>>
>> Regards,
>> Graham
>> --
>>
>
> Just to tie this off: the fun here began with a message from buildconf:
>
> You don't have a copy of the apr source in srclib/apr.
> Please get the source using the following instructions,
> or specify the location of the source with
> --with-apr=[path to apr] :
>
>    svn co http://svn.apache.org/repos/asf/apr/apr/trunk srclib/apr
>
> So, if srclib is no longer a good idea, I suppose that buildconf needs
> a slight improvement. Anyway, mission accomplished.

Hopefully r1389060 gets rid of the bad hints and provides
basically-correct instructions regarding APR/APR-util in INSTALL which
others can massage as appropriate.

-- 
Born in Roswell... married an alien...
http://emptyhammock.com/

Mime
View raw message