On 1/20/2012 2:06 PM, Gregg L. Smith wrote:
>
> Due to the fact that right now, you have to convert to VC9 first, then convert to VC10,
I
> have some insight here that I am sure you do as well.
Good point...
> If you have done this, you may remember how long that last conversion takes to accomplish.
> I can convert in VC9 from dsw/dsp in under a minute. The last time I tried converting
VC9
> to VC10 it took a long, long time. Minutes, many minutes.
>
> I would have to assume converting up from VC7 would be same on VC9 as converting 9 to
10.
> Even if not, from 7 to 10 would again, be a slow process.
That is troublesome. However, it only affects GUI interaction? It should
not impact .mak based builds.
> This was my technical reason behind my request to keep the dsw/dsp files while also
> supplying VC10 sln/vcproj as well. This way, all are covered, and no one has to wait
a
> long time for the conversion. Sure, many are EOL but none the less still in use.
Will consider this. Or provide a much more efficient transition.
|