geronimo-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Matt Hogstrom <m...@hogstrom.org>
Subject Re: VMware on GBuild?
Date Sat, 29 Jul 2006 18:21:43 GMT
I wasn't sure if Aaron had his systems in a colo which I think he alluded to earlier.

Jason Dillon wrote:
> IMO its easier to just using a NAT'ing router... instead of mucking with 
> a proxy.  Routers w/NAT are relatively cheap or if you have a Linux box 
> w/2 NICs you can roll any sort of fancier router you want... at the cost 
> of a bit more admin foo.
> 
> --jason
> 
> 
> On Jul 28, 2006, at 5:47 PM, Matt Hogstrom wrote:
> 
>> Just getting back to the multiple images behind a gateway system.  I 
>> was thinking the other images could simply go through the gateway 
>> using a proxy rather than having to mees around with IP layer tricks.
>>
>> Jason Dillon wrote:
>>> Not sure... does ActiveMQ support it?  If so... then sure... if 
>>> not... well, then we'd have to write a transport (er something like 
>>> that).
>>> Why?
>>> --jason
>>> On Jul 28, 2006, at 12:10 PM, Matt Hogstrom wrote:
>>>> Could it be through a proxy?
>>>>
>>>> Jason Dillon wrote:
>>>>> Agents make a TCP connection to the central AMQ router running on 
>>>>> stan.gbuild.org... and then ActiveMQ takes care of the rest.  So, 
>>>>> its not push or pull... but the Agent must initiate the connection.
>>>>> --jason
>>>>> On Jul 28, 2006, at 11:41 AM, Aaron Mulder wrote:
>>>>>> On 7/28/06, Jason Dillon <jason@planet57.com> wrote:
>>>>>>> I'm no expert on how the TCK runs, but I do not believe that
you 
>>>>>>> need
>>>>>>> a public IP.  Though, with out a public IP, we can't use Cacti
to
>>>>>>> monitor the hosts, or ssh to them directly to admin them... 
but if
>>>>>>> you dedicate one host as a gateway then we can get past that...
and
>>>>>>> might even be able to setup port forwarding for SNMP/Cacti 
>>>>>>> monitoring.
>>>>>>>
>>>>>>> If there is any other issue that requires a public IP I am not
aware
>>>>>>> of it... and we should remove the need for it if one exists.
>>>>>>
>>>>>> How does the GBuild master communicate with the GBuild slaves?  Is
it
>>>>>> all pull from the slaves?
>>>>>>
>>>>>> Thanks,
>>>>>>     Aaron
> 
> 
> 
> 

Mime
View raw message