geronimo-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Jason Dillon <ja...@planet57.com>
Subject Re: VMware on GBuild?
Date Sat, 29 Jul 2006 01:04:31 GMT
IMO its easier to just using a NAT'ing router... instead of mucking  
with a proxy.  Routers w/NAT are relatively cheap or if you have a  
Linux box w/2 NICs you can roll any sort of fancier router you  
want... at the cost of a bit more admin foo.

--jason


On Jul 28, 2006, at 5:47 PM, Matt Hogstrom wrote:

> Just getting back to the multiple images behind a gateway system.   
> I was thinking the other images could simply go through the gateway  
> using a proxy rather than having to mees around with IP layer tricks.
>
> Jason Dillon wrote:
>> Not sure... does ActiveMQ support it?  If so... then sure... if  
>> not... well, then we'd have to write a transport (er something  
>> like that).
>> Why?
>> --jason
>> On Jul 28, 2006, at 12:10 PM, Matt Hogstrom wrote:
>>> Could it be through a proxy?
>>>
>>> Jason Dillon wrote:
>>>> Agents make a TCP connection to the central AMQ router running  
>>>> on stan.gbuild.org... and then ActiveMQ takes care of the rest.   
>>>> So, its not push or pull... but the Agent must initiate the  
>>>> connection.
>>>> --jason
>>>> On Jul 28, 2006, at 11:41 AM, Aaron Mulder wrote:
>>>>> On 7/28/06, Jason Dillon <jason@planet57.com> wrote:
>>>>>> I'm no expert on how the TCK runs, but I do not believe that  
>>>>>> you need
>>>>>> a public IP.  Though, with out a public IP, we can't use Cacti to
>>>>>> monitor the hosts, or ssh to them directly to admin them...   
>>>>>> but if
>>>>>> you dedicate one host as a gateway then we can get past  
>>>>>> that... and
>>>>>> might even be able to setup port forwarding for SNMP/Cacti  
>>>>>> monitoring.
>>>>>>
>>>>>> If there is any other issue that requires a public IP I am not  
>>>>>> aware
>>>>>> of it... and we should remove the need for it if one exists.
>>>>>
>>>>> How does the GBuild master communicate with the GBuild slaves?   
>>>>> Is it
>>>>> all pull from the slaves?
>>>>>
>>>>> Thanks,
>>>>>     Aaron


Mime
View raw message