cloudstack-users-cn mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From "linuxbqj@gmail.com" <linux...@gmail.com>
Subject Re: 为什么我的双网卡绑定,总是一个网卡有流量呢。
Date Mon, 21 Jul 2014 05:20:23 GMT
mode=0:平衡负载模式,有自动备援,但需要”Switch”支援及设定。

http://support.huawei.com/ecommunity/bbs/10155553.html

2014-07-18 13:39 GMT+08:00 虚无缥缈 <83675086@qq.com>:
> A、B两台设备,都是双网卡绑定,mode=0,交换机上也做了端口组,交换机是cisco
2960,A上起了nfs,B上挂载nfs,然后进行dd测试,cacti上看总是一个端口流量,手动down掉一个网卡,另外一个网卡才有流量。
>
> A:
> [root@backup ~]# cat /proc/net/bonding/bond0
> Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
>
>
> Bonding Mode: load balancing (round-robin)
> MII Status: up
> MII Polling Interval (ms): 100
> Up Delay (ms): 0
> Down Delay (ms): 0
>
>
> Slave Interface: em1
> MII Status: up
> Speed: 1000 Mbps
> Duplex: full
> Link Failure Count: 1
> Permanent HW addr:
> Slave queue ID: 0
>
>
> Slave Interface: em2
> MII Status: up
> Speed: 1000 Mbps
> Duplex: full
> Link Failure Count: 0
> Permanent HW addr:‍
>
>
>
> B:
> root@storage-xen bak_201]# cat /proc/net/bonding/bond0
> Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
>
>
> Bonding Mode: load balancing (round-robin)
> MII Status: up
> MII Polling Interval (ms): 100
> Up Delay (ms): 0
> Down Delay (ms): 0
>
>
> Slave Interface: em1
> MII Status: up
> Speed: 1000 Mbps
> Duplex: full
> Link Failure Count: 0
> Permanent HW addr:
> Slave queue ID: 0
>
>
> Slave Interface: em2
> MII Status: up
> Speed: 1000 Mbps
> Duplex: full
> Link Failure Count: 0
> Permanent HW addr:
> Slave queue ID: 0‍
>
>
>
> 交换机:
> interface Port-channel1
>  switchport access vlan 150
>  switchport mode access‍
>
>
>
> interface GigabitEthernet0/3
>  switchport access vlan 150
>  switchport mode access
>  channel-group 1 mode on
>  spanning-tree portfast
> !‍
>
> interface GigabitEthernet0/10
>  switchport access vlan 150
>  switchport mode access
>  channel-group 1 mode on
>  spanning-tree portfast‍



-- 
白清杰 (Born Bai)

Mail: linuxbqj@gmail.com

敬畏耶和华是智慧的开端

Mime
View raw message